Configuring the Routing Table
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|180
n
To route traffic from any source, leave the default value Any
n
To route traffic from a specific IPv4 address:
a. Click the value Any.
b. Select Specified IP Address.
c. Configure the required IP Address.
d. Configure the required Subnet Mask.
e. Click OK.
6. In the Service column:
n
To route traffic for all services (protocols), leave the default value Any
n
To route traffic for a specific service:
a. Click the value *Any.
b. Select the required service object or a service group object.
Notes:
l
You can select only one service object or one service group
object.
l
In the bottom right corner, you can click New > Service, or
Service group to create a custom service or a group of
services.
c. Click OK.
7. In the Next Hop column:
To Next Page
Loading...
