Managing Internal Certificates
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|194
After you configure a cluster, you can select to Enable or Disable the cluster.
Notes:
n
This release supports only the High Availability Cluster.
One Cluster Member is Active. The other Cluster Member is Standby.
If there is a failure on the Active Cluster Member, the cluster fails over, and the
current Standby Cluster Member becomes the new Active Cluster Member.
n
After you configure the cluster, when you connect to the Cluster Virtual IP
address, the cluster automatically redirects you to the current Active Cluster
Member.
To log in to specific Cluster Member, you must connect to the physical IP
address of that Cluster Member.
To Next Page
Loading...
