Quantum SPARK 1500 - Page 220

Working with the Firewall Access Policy
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|220
5. To limit the rule to a certain time range, select Apply only during this time and select the
start and end times.
6. In outgoing rules, to limit the download traffic rate, select Limit download traffic of
applications to and enter the Kpbs rate.
7. In outgoing rules, to limit the upload traffic rate, select Limit upload traffic of
applications to and enter the Kpbs rate.
8. In incoming rules, to match only for encrypted VPN traffic, select Match only for
encrypted traffic.
9. Click Apply
The rule is added to the outgoing or incoming section of the Access Policy.
To clone a rule:
Clone a rule to add a rule that is almost the same as the one that already exists.
1. Select a rule and click Clone.
2. Edit the fields as necessary.
3. Click Apply
To edit a rule:
Note - For Access Policy rules, you can only edit the tracking options for automatically
generated rules.
1. Select a rule and click Edit.
2. Edit the fields as necessary.
3. Click Apply
To delete a rule:
1. Select a rule and click Delete.
2. Click Yes in the confirmation message.
To enable or disable a rule:
n
To disable a manually defined rule that you have added to the rule base, select the rule
and click Disable.
n
To enable a manually defined rule that you previously disabled, select the rule and click
Enable.