SD-WAN
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|238
Note - After you configure multiple connections, you can only work in the
High Availability mode.
a. From the left tree, click Access Policy.
b. In the middle pane, expand the section Firewall and click SD-WAN.
c. Scroll down until you see the tabs Performance and Policy.
d. Below the section Custom Rules, move the slider Smart SD-WAN uses
prioritize to the right to enable this option.
e. On the right side of this slider, click Configure.
The Smart SD-WAN Settings window opens.
f. In the Link Utilization section, select the Link Utilization method for Smart SD-
WAN:
n
Link Aggregation - Selected by default. The appliance uses all SD-WAN
interfaces that meet the threshold criteria.
n
Prioritize - The appliance uses the Internet connections based on the
configured priority order.
To change the priority order of connections:
i. Click and hold the applicable table row.
ii. Drag the table row up or down to the required position.
iii. Release the mouse button.
iv. Click Save.
4.
If necessary, configure custom SD-WAN rules
These rules configure a steering behavior for specific application traffic. The steering
behavior determines how the appliance sends traffic to the Internet. The default
behavior is Local Breakout. See
"Predefined Steering Behavior Objects" on page242
and
"Configuring User-Defined Steering Behavior Objects" on page242
.
The appliance applies the rules in the order you put them in the policy.
To Next Page
Loading...
