Quantum SPARK 1500 - Page 290

Advanced Threat Prevention Engine Settings
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|290
To enable POP3S or IMAP scans:
1. On the Threat Prevention > Engine Settings page, under Anti-Virus Scanned
protocols, select the Mail (SMTP, POP3 and IMAP) checkbox.
2. On the Access Policy > SSL Inspection Policy page, select the checkbox to enable
SSL traffic inspection.
3. Under Protocols to inspect, select POP3S or IMAP.
4. Click Apply
To configure the Anti-Virus settings:
1. Select one of the protected scope options:
n
Scan incoming files from - Select one of these interfaces from which to scan
incoming files:
l
External and DMZ - Files that originate from external and the DMZ interfaces
are inspected.
Note - DMZ is not supported in 1530 / 1550 appliances.
l
External - Files that originate from external interfaces are inspected.
l
All - Files transferred between all interfaces are inspected.
n
Scan both incoming and outgoing files - Files that originate from outside the
organization and from within the organization to the Internet are inspected.
2. Select the protocols to scan for the selected scope:
n
HTTP (on any port)
n
Mail (SMTP, POP3 and IMAP