Quantum SPARK 1500 - Page 317

Configuring VPN
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|317
f. In the section "VPN Remote Access users can connect via", select the
applicable Remote Access VPN clients:
n
Check Point VPN clients - Install a VPNclient on your desktop or laptop.
n
Mobile client - To connect on your smartphone or tablet (iOS or Android).
n
SSL VPN - To connect through SSL VPN. Enter the IP address in your
web browser.
n
Windows VPN client - L2TP. For either Windows or Mac, connect with a
pre-shared key. For instructions, click How to connect.
To configure VPN remote access methods:
i. Select the checkbox next to the desired method and click How to
connect....
The Usage window opens.
ii. Follow the instructions on the screen.
iii. Close the window.
iv. Click Apply.
g. At the bottom of the page, click Apply.
Note - When the Remote AccessVPN blade is managed by Cloud Services,
a lock icon appears. You cannot toggle between the On and Off states. If you
change other policy settings, the change is temporary. Any changes you
made locally are overridden in the next synchronization between the gateway
and Cloud Services.
2.
Configure users and user groups for the Remote Access VPN
Follow the applicable procedure:
Adding a new local user
a. Go to VPN >Remote Access > Remote Access Users.
b. Click Add.
The New Local User window opens.
c. Enter the required information in the fields.
Note - The Email and Phone number fields are optional. However, if
you want to give this user Remote Access VPN permissions, this
information is necessary for Two-Factor Authentication during the
Remote Access VPN connection.
d. Select Remote Access permissions.