Configuring VPN Sites
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|343
In the Advanced tab:
Note - When you finish the new VPN site configuration, click Save.
n
Settings
l
Select to configure if the remote site is a Check Point Security Gateway. To enable
permanent VPN tunnels, Select the checkbox.
l
Select to disable NAT for this site. The original IP addresses are used even if hide
NAT is defined.
n
Encryption method
Select the IKE version:
To Next Page
Loading...
