Quantum SPARK 1500 - Page 355

Configuring Advanced Site to Site Settings
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|355
3. If your default shell is Gaia Clish, then go to the Expert mode:
expert
4. Configure the required value for the Registry parameter:
ckp_regedit -a SOFTWARE/CheckPoint/VPN1 BestRoutingSenderIP
False
5. Examine the value of the Registry parameter:
ckp_regedit -p
SOFTWARE\\CheckPoint\\VPN1 |
grep BestRoutingSenderIP
6. Restart all Check Point services (this interrupts all traffic):
cpstop ; cpstart
To configure IKEv2 ID Type to an IP address based on the OS routing:
Important - Schedule a maintenance window.
1. Connect to the command line on the Quantum Spark appliance.
2. Log in.
3. If your default shell is Gaia Clish, then go to the Expert mode:
expert
4. Configure the required value for the Registry parameter:
ckp_regedit -a SOFTWARE/CheckPoint/VPN1 BestRoutingSenderIP
True
5. Examine the value of the Registry parameter:
ckp_regedit -p
SOFTWARE\\CheckPoint\\VPN1 |
grep BestRoutingSenderIP
6. Restart all Check Point services (this interrupts all traffic):
cpstop ; cpstart