Managing Service Groups
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|398
To delete a service group:
1. Select the group from the list. Note that you can only delete a user defined service group.
2. Click Delete.
3. Click Yes in the confirmation message.
To filter for a specified service group:
1. In the Type to filter box, enter the service group name or part of it.
2. As you enter text, the list is filtered and shows matching results.
Built-in System Service Groups
Some built-in service groups represent Check Point's ability to perform deep inspection of a
specific protocol. Such system service groups cannot be deleted. They contain a list of built in
services which you can restore if you edit the content of such groups by clicking Reset.
Some system service groups have additional configuration which affect the way the deep
inspection is performed.
DNS - The Firewall settings tab lets you configure NAT support over DNS. Note that this option
affects the performance of DNS traffic and is normally not needed unless your organization
uses both NAT and an internal DNS server accessible to the Internet. The IPS settings tab lets
you configure how and when DNS deep inspection is performed. Select the relevant options.
To Next Page
Loading...
