Configuring Cloud Services
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|45
Workflow to connect to Cloud Services:
1. Connect to Cloud Services Provider and establish a secure connection.
Make sure the gateway registration information is correct.
2. Get the security policy and settings.
3. Install the security policy and settings.
When you connect for the first time, the appliance must verify the certificate of the Cloud
Services Provider against its trusted Certificate Authority list. If verification fails, you get a
notification message. You can stop or ignore the verification message and continue.
To connect to Cloud Services:
1. Click Configure or Edit.
The Configure Cloud Services window opens.
2. Select Activation key or Activation details and enter the specified information.
3. Click Apply
The appliance tries to connect to the Cloud Services Provider. The Cloud Services
section shows a progress indicator and shows the connection steps.
Note - If you see a message that the identity of your Cloud Services Provider cannot
be verified but you are sure of its identification, click Resolve and then Ignore and
reconnect.
When connectivity is established, the Cloud Services section at the top of the page appears:
n
The date of the synchronization
n
The On/Off toggle shows that Cloud Services is turned on.
A Cloud Services Server widget appears on the status bar and shows Connected. If you click
this widget, the Cloud Services page opens.
To test connectivity to the Cloud Services:
1. Connect to the command line on the appliance.
2. Log in to the Expert mode.
3. Run this command:
runCliCommand.lua testcloudconnectivity [<IP Address or FQDN>]
To Next Page
Loading...
