Quantum SPARK 1500 - Page 95

Managing the Device
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|95
9. Go from the Expert mode to Gaia Clish:
n
If your default shell is Gaia Clish:
exit
n
If your default shell is Expert mode:
clish
10. Enable the use of the configuration file:
set os-settings advanced-settings use-secondary-mccmnc-file
true
Switching the Active Image
For Security Gateways with cellular Internet connections, you can switch the active image
between carrier-approved firmware configurations.
The image contains files used to configure the module for use with specific carriers. Multiple
images can be stored on the device. During a firmware upgrade, you can add images
packages to the module or replace an image with a newer version.
Note - You can only switch to an image already uploaded to the module.
The image package contains these files:
n
Firmware file – Contains the module's firmware.
n
Carrier Configuration file (the Product Release Information or PRI) – Contains custom
settings for a specific carrier and is linked internally to a specific firmware file.
The module runs an active image which contains a single uncompressed copy of a firmware
file and a single configuration file.
To see a list of available carriers and their image packages, go here.
n
EM7455 – Global region
n
EM7430 – APAC region
Use cases:
Some carriers require the module to run a specific carrier configuration file, and may also
request this for the certification process. In addition, the carrier configuration file ensures
the use of carrier-specific parameters when you register with that carrier.