@ her Enf@rm @n
Troubleshooting
If you're having problems with your camcorder, try the solutions in this section. If the
problem still exists, please consult your nearest RCA authorized service center.
External noise and interIi'rence (from a ['V a radio, etc.) might prevent your camcorder
fiom functioning properly. In such cases, first disconnect the power supply unit (batte W
pack, AC power supply, etc.); and then reconnect it and proceed as usual fiom the
beginning.
Power Problems
No power is supplied.
The I)att_"W pack has not I)_'_'n attach_'d correctly (see page l O.
The battery pack is not charged (see page l O.
The power supply has not been correctly connected (see [}age lO).
The power suddenly goes off and does not come back on by itself.
Turn the" Power switch off and th_'n on again.
The battery pack has completely discharged.
Remove the tape and disconnect the power source, then after a fi'w minutes, try
reconnecting and turning the power back on. If it still does not come on, consult your
nearest RCA authorized service center.
Feature and Function Problems
Some menus or features are not available.
The Power switch is set to _. Set it to [] and nT again.
Vertical white lines appear when shooting a very bright object.
This sometim_'s occurs wh_'n th_'t"_" is a lot of contrast b_'tw_'en the" background and the"
object. It is not a dc[i'ct of the" camcord_'r. Try shooting [)()in a di[}'_'r_'nt angt_" or adjusting
the lighting conditk)ns.
110
To Next Page
Loading...
