@ her Enf@rmat @n
Things to Avoid
Do not att_'mpt to disassembh" tho camcordcr. Th_,ro aro no user s_'_dcoabh, part_
inside.
Avoid operating the camcorder immediately after moving it fi-om a cold location to a
warm location. Give the camcorder 1 1/2 to 2 hours to reach a stable temperature
befi)re inserting a tape.
In co|d to warm conditions, condensation might occur causing the tape to stick to the
recording heads and damage the camcorder or tapes.
Never aim the camcorder at tim sun or oflmr bright objects.
Do not leave the camcorder in direct sunlight for ext_,nded periods of time. ['he
resulting heat buildup might permanently damage the camcorder's internal parts or
reduce the lif_" of the clock battel T.
Do not operate the camcorder in exffemely humid environments.
I)o not operate the camcorder near tim ocean as salt water or spray might damage the
internal parts of the camcorder.
Do not operate the camcorder for extended periods in temperatures below 40F (4C)
or above 95F (35 C).
Do not expose tim camcorder or power supply/charger to rain or moisture. If any
component becomes wet, turn off the power and take the unit to an authori_'x_d RCA
camcorder service provider.
Do not use any power supply/charger or batt_'ries other than the ones specified for the
camcorder. []sing the wrong accessories might cause damage to the camcorder.
119
To Next Page
Loading...
