@ her Enf@rmat @n
Cleaning The Camcorder
1. Clean the' exterior wiping g_,mly with a soft cloth. For heavy dirt use diklted, mikl
soap and wring the cloth well. ['hen wipe again with a dl T cloth.
2. Open tile LCI) monitor and wipe it gently with a soft, dl T cloth. Close it when done.
3. 'lk) clean the lens, blow it with air using a blower brush. Wipe gently with tens
cleaning paper.
4. 'lk) clean tile viewfinder, raise it to tim vertical position. Carefully <)pen the cover on
the bottom of the viewfinder. Insert a lens blower or soft cloth into tim gap to clean
tile interior. Close the cover and tilt tile viewfinder back to the horizontal position.
Notes:
Avoid using strong cleaning agents such as alcohol.
Cleaning should be done only after the power supply has been disconnected,
Mold may form if the lens is left dirty.
When using a cleaner or chemically treated cloth, refer to the cautions of each
product,
Proper Care and Storage
Ke_,p dirt f_om entering the cm_acorder s cassette, tap_ _ door. I)ust and grit are abrasive
and cause, excessive wear to both the" recording/playbac]_ heads and tape's.
Always cap the lens when the camcorder is not in use.
Bef_re handling the, camcorder l_aake sure your hands and face are f_'ee fl'om any
chemical products such as suntan lotion, as it might damage the' finish.
The c312acorder might b_' dalTlaged by ilaapl'oper stol'ag_' oi" handling, l)o not sub}ect the
camcorder io swinging, shaking, or dropping.
Do not store the camcorder in temperatures below 22F (30C) or above 149F (65 C).
When the camcorder is not in use, always remove the tape and AC power supply/
charger or batte W.
Retain the original carton f\_r future storage or shipping purposes.
117