@ her Inf@rmati@n
Video Recording
When th__ Powder switch is set to _ or [] and the LCD monitor is opened Jt Jn Jngh'
of 25 or more, the LCI) monitor switches on Jnd the viewfinder switches off
_mtom;]tically to save power.
The cassette tape holder can't be opened unless a power supply is attached.
There may be a delay after you slide OPEN/EJECT until the cassette tape holder
opens, l)o not use force.
The time required to calculate the remaining tape length, and the accuracy of the
calculation, may vary according to the type of tape used.
?24PI,J l!7\_1)appears when the tape reaches its end, and the power goes off
automatically if leR in this condition fl)r 5 minutes.
72iPI,J l!7\_l) also appears when a tape is loaded and is already at its end.
While shooting, sound is not heard from the speaker.
Tapes
A power supp]y must b_" Jttach_'d to ]oacl or eiect J tap_ ".
When loading a tape, it takes a few seconds fl)r the cassette tape holder open. Never
apply fl_rce to the holder or door cover as this might result in damage to the
camcorder and void the warranty.
If ti_e cassette tape holder does not {)pen after a fi'w seconds, close the holder door
and try again. If it still does not open, Wrn the camcorder off, then on again.
If the tape does not load properly, open the cassette tape holder door and fully
remove the unit. Wait a few minutes and reinsert it.
Closing the cassette tape holder door bef\_re the holder comes out may damage the
camcorder.
Even when the camcorder is turned off. a tape can still be loaded or unloaded. Af_er
the cassette tape holder is dosed with the camcorder swflched off, though, it may
not recede. Turn the power on before loading or unloadhig tapes.
When recording, once tim cassette tape holder door is open, a blank portion will be
recorded on the tape or a previously recorded scene will be taped over regardless of
whether the tape holder came out or not.
115
To Next Page
Loading...
