Dubbing to a VCR
1. Following the, illustration in this chapter, connect the camcorder and the VCIL
2. Press in the PI. SH OPEN button in the direction of the arrow and op_,n the LCI)
3. Set the VII)EOiI)SC switch to VII)EO.
4. Press in the Lock button while setting the camcorder's Power switch to 1'_"1, turn on
the VCR's power, and insert the appropriate tapes in the camcorder and the VCR.
5. Make sure the VCR is in the appropriate AUX mode and the Record Pause mode.
6. lse the camcorder's Play mode to find a spot just before the edit in point. Once it is
reached, press lqll on tile camcorder.
7. When you're ready to start recording, press _/ll on tile camcorder and press tile
appropriate record button on the VCR.
8. When you want to stop recording, press tile VCRs pause button and press _/ll on
the camcorder.
9. Repeat steps 6 through 8 R)r additional editing, then stop the VCR and camcorder
when finished.
Note: If you want to dub still images, play back the images, and instead of doing
the above steps 5 through 7,activate the VCR'srecord mode.
53
To Next Page
Loading...
