RED CAT TEAL 2 - Programming a Rally Point; Vehicle Setup; Button & Joystick Setup

To Next Page

To Previous Page

Note: Only one mission can be on the AV

at a time. If you upload a new mission, it

will overwrite the current mission.

3.6.3 PROGRAMMING A RALLY POINT

To program a rally point:

1. Touch the Main menu icon.

2. Select Plan.

3. A Mission Plan window will appear.

4. Select Rally.

5. Add the rally point by touching the location on the map or by entering the exact

coordinates in the field provided.

6. Select either Upload Required to load the mission onto the AV or select File to save

the mission and upload at a later time.

Note: The AV will go to the RTL or rally

point, whichever is closest to the AV.

3.7 VEHICLE SETUP

Use this screen to customize safety parameters, calibrate the AV, and to customize the

joystick and buttons configurations on the GCS.

3.7.1 BUTTON & JOYSTICK SETUP

1. Connect the AV and the GCS.

2. Touch the Main menu icon.

3. Select Vehicle Setup.

4. Select Joystick.

5. Use the General, Button

Assignment, and Advanced

windows to customize the joystick and buttons, if so desired.

6. Select the Set Teal Defaults in the Advanced screen to reset all settings, if needed.