35
The default height of follow me is 8 meters/26 feet above the home (arming) position.
Once engaged, the primary joysticks on the TAC can be used to dynamically adjust
altitude, distance, and bearing.
Follow Height is controlled with the Throttle stick. Center the stick to remain at current
altitude. Push the stick up to ascend. Pull the stick down to descend.
Follow Distance is controlled with the Pitch stick. Center the stick to remain at current
distance. Push the stick forward to increase follow distance. Pull the stick back to decrease
follow distance.
Follow Angle is controlled with the Roll stick. Center the stick to remain at current bearing
relative to controller. Move the stick to the left, and the aircraft will adjust its bearing to
your left. Move the stick to the right, and the aircraft will adjust its bearing to your right.
Use the Yaw joystick to rotate the aircraft while Follow Me is engaged.
Note that Follow Me must be disengaged to regain normal joystick flight controls.
Only use Follow Me mode in wide open areas that are unobstructed by trees, power lines,
houses, etc.
To Next Page
Loading...