Because RFL™ and Hubbell® have a policy of continuous product improvement, we reserve the right to change designs and specifications without notice.
Table 7-2 - continued. Valid command field entries
Command Description
STATUS2?
Used to determine the redundancy status information in the
common module identified in the address
field.
Co
mmand example:
4:DI-A:EVENT:1,STATUS2?:;
Response:
*OK
FROM NET ADDRESS=4
>>>ALERT AT SHELF<<<
STAN
DBY COMMON MODULE ACTIVE;
CONFIG2?
Used to determine the redundancy configuration settings in the common module identified in the
address field.
Co
mmand example:
1:TERM:CONFIG2?:;
E1 Re
sponse:
*OK
FROM NET ADDRESS=1
FRAMER=E1
MAIN=ON
SWITCH=AUTO
CSU=RFL
PRSQ=DISA
POSQ=DISA
SWAP=0.6s
UNIT=CM4R
(MODE SWITCH=AUTO)
HEAD=75
CRC4=ON;
IMUX
2000E1 RFL Electronics Inc.
February 28, 2006 7-12 (973) 334-3100
To Next Page
Loading...
