Using NetWare
25
1
F In the [Available objects] box, click the volume in which the print queue is
created, and then click [OK].
G Check the settings, and then click [Create].
H Select the object in which the printer is located, and then click [Create] on
the [Object] menu.
I In the [Class of new object] box, click [Printer], and then click [OK]. For Net-
Ware 5, click [Printer (Non NDPS)].
J In the [Printer name] box, enter the printer name.
K Select the [Define additional properties] check box, and then click [Create].
L Click [Assignments], and then click [Add] in the [Assignments] area.
M In the [Available objects] box, click the queue you created, and then click [OK].
N Click [Configuration], click [Parallel] in the [Printer type] list, and then click
[Communication].
O Click [Manual load] in the [Communication type] area, and then click [OK].
P Check the settings, and then click [OK].
Q Select a context specified using NIB Setup Tool, and then click [Create] on
the [Object] menu.
R In the [Class of new object] box, click [Print Server], and then click [OK]. For
NetWare 5, click [Print Sever (Non NDPS)].
S In the [Print Server Name] box, enter the print server name.
Use the same print server name specified using NIB Setup Tool.
T Select the [Define additional properties] check box, and then click [Create].
U Click [Assignments], and then click [Add] in the [Assignments] area.
V In the [Available objects] box, click the queue you created, and then click [OK].
W Check the settings, and then click [OK].
X Start the print server by entering the following from the console of the Net-
Ware server.
If the print server is in operation, quit and restart it.
❖ To exit
CAREE: unload pserver
❖ To start
CAREE: load pserver print_server_name
To Next Page