Monitoring and Configuring the Printer
72
2
❖ Adding IP Routing Table
msh> route add {host|net} “destination” “gateway”
• Adds a host or network route to “destination”, and a gateway address to
“gateway” in the table.
• Specify the IP address to destination and gateway.
• Host becomes the default setting.
❖ Setting the Default IP Gateway
msh> route add default “gateway”
❖ Deleting specified IP destination from Routing Table
msh> route delete {host|net} “destination”
• Host becomes the default setting.
• IP address of destination can be specified.
❖ Route initialization
msh> route flush
Note
❒ The maximum number of routing tables is 16.
❒ Set a gateway address when communicating with devices on an external net-
work.
❒ The same gateway address is shared by all interfaces.
set
Use the “set” command to set the protocol information display “active” or “in-
active”.
❖ View settings
The following command displays protocol information (active/inactive).
msh> set tcpip
msh> set appletalk
msh> set netware
msh> set smb
msh> set protocol
• When protocol is specified, information about TCP/IP, AppleTalk, Net-
ware, SCSI print, and SMB appears.
msh> set ftp
msh> set rsh
msh> set diprint
msh> set web
msh> set snmp
To Next Page
Loading...
