Using a Printer Server
28
1
❖ To quit
CAREE: unload pserver
❖ To start
CAREE: load pserver print_server_name
Note
❒ If the printer works as configured, the message “Waiting for job” appears.
Setting up using NIB Setup Tool
A Log on to the file server as a supervisor or supervisor equivalent.
B Start NIB Setup Tool from the [Start] menu.
C Click [Property Sheet], and then click [OK].
D Select the printer you want to configure, and then click [Finish].
A dialog box prompting you to perform the remaining configuration tasks in
the Web browser appears. Click [OK], and then wait until Web Image Monitor
starts automatically.
E A dialog box for entering the [User Name] and [Password] appears.
Enter the user name and password, and then click [OK].
For details about the login user name and password, consult your network
administrator.
F Click [Configuration] in the left area, click [Network], and then click [NetWare].
G Confirm the settings, and then click [Apply].
Configuration is now complete. Wait several minutes before restarting Web
Image Monitor.
H Click [Logout].
Reference
For details, see p.22 “Setting Up as a Print Server (NetWare 3.x)”
Setting Up as a Remote Printer (NetWare 4.x, 5 / 5.1, 6 / 6.5)
Follow the procedure below to use the printer as a remote printer under Net-
Ware 4.x, 5 / 5.1 and 6 / 6.5.
Important
❒ To use the printer as a remote printer under NetWare 4.x, 5 / 5.1, 6 / 6.5, set
it to NDS mode.
❒ Do not use the printer as a remote printer when Pure IP is used.
To Next Page