Ricoh 3045 - Configuring the Energy Saver Mode; Setting a Password

Using SmartDeviceMonitor for Admin
45
2
Note
❒ For details about setting restrictions, see SmartDeviceMonitor for Admin
Help.
Configuring the Energy Saver Mode
Follow the procedure below to configure Energy Saver mode.
A Start SmartDeviceMonitor for Admin.
B On the [Group:] menu, point to [Search Device], and then click [TCP/IP],
[IPX/SPX] or [TCP/IP SNMPv3].
A list of machines using the selected protocol appears.
Select the protocol of the machine whose configuration you want to change.
If you are using TCP/IP SNMP v3, enter the user authentication.
C Select the machine whose settings you want to make.
To make settings for all machines in the selected group, select no machine.
D On the [Group:] menu, point to [Energy Save Mode], point to [Set Individually] to
make the settings for only the selected machine or point to [Set By Group] to
make the settings for all machines in the selected group, and then click [On]
or [Off].
E Quit SmartDeviceMonitor for Admin.
Note
❒ For details about the setting for Energy Saver mode, see SmartDeviceMon-
itor for Admin Help.
Setting a Password
Follow the procedure below to set a password.
A Start SmartDeviceMonitor for Admin.
B On the [Group:] menu, point to [Search Device], and then click [TCP/IP],
[IPX/SPX] or [TCP/IP SNMPv3].
A list of machines using the selected protocol appears.
Select the protocol of the machine whose configuration you want to change.
If you are using TCP/IP SNMP v3, enter the user authentication.
C In the list, select a machine whose configuration you want to change.