Ricoh 3045 - Page 72

Transmission
62
1
C Enter the IP-Fax destination, and then press [OK].
If you have set both of “Enable H.323” and “Enable SIP” parameters to “On”
with “IP-Fax Settings” under “Facsimile Features”, [Protocol] appears. Press
this button to select a protocol to be used.
If you enter an incorrect character, press [Backspace] or [Delete All]. Then, re-
enter the characters correctly.
To change the IP-Fax destination after pressing [OK], press [Edit Dest.], re-enter
an IP-Fax destination, and then press [OK].
The destination is specified.
Press [ProgDest] in order to store the entered IP-Fax destination in the Address
Book.
If you do not want to add a destination, proceed to step
F
.
D To add a destination, press [Add].
It is not necessary to press [Add] when adding destinations using the destination list.
E Specify the next destination.
Pressing switches the destination list between fax number, e-mail ad-
dress, and IP-Fax destination.
To add another destination, repeat steps
D
and
E
.