SERVICE RAM ADDRESSES
B465 5-48 SM
Bit 4: Restricted Access using personal codes 0: Off, 1: On
Bits 5 to 7: Not used
4000C6(H) - User parameter switch 06 (SWusr_06)
Bit 0: TT print 0: Off, 1: On
Bits 1 to 3: Not used
Bit 4: Batch transmission 0: Off, 1: On
Bits 5 to 7: Not used
4000C7(H) - User parameter switch 07 (SWusr_07)
Bits 0 and 1: Not used
Bit 2: Parallel memory transmission 0: Off, 1: On
Bit 3: Not used
Bit 4: Use of the 3 key for tonal signals 0: Off, 1: On
Bits 5 to 7: Not used
4000C8(H) - User parameter switch 08 (SWusr_08)
Bits 0 to 5: Not used.
Bits 6 and 7: Forwarding
Bit 7 6 Setting
X 0 Disabled
0 1 Faxes from senders whose RTIs/CSIs are specified for this
feature are forwarded.
1 1 Faxes from senders whose RTIs/CSIs are not specified for this
feature are forwarded.
4000C9(H) - User parameter switch 09 (SWusr_09)
Bits 0 and 1: Memory lock
Bit 0 1 Setting
X 0 Disabled
0 1 Faxes from senders whose RTIs/CSIs are specified for this
feature are kept in the memory until a memory lock ID is entered.
1 1 Faxes from senders whose RTIs/CSIs are not specified for this
feature are kept in the memory until a memory lock ID is entered.
Bits 2 to 5: Not used
Bit 6: Inclusion of the Yes key when Quick Dials are continuously selected for
destinations 0: Not needed, 1: Needed
1: The user must press the Yes key after each Quick Dial key. This is to
prevent the user from selecting incorrect destinations.
Bit 7: Not used
4000CA(H) - User parameter switch 10 (SWusr_0A)
Bits 0 to 6: Not used
Bit 7: Halftone type 0: Error diffusion, 1: Dither
4000CB(H) - User parameter switch 11 (SWusr_0B)
Bits 0 to 5: Not used
Bit 6: Printout of messages received while acting as a forwarding station
0: Off, 1: On
Bit 7: Not used
To Next Page
Loading...
