• To make the settings effective, turn the main switch off and on after exiting service mode.
Remarks
Display on the Control Panel Screen
Since the maximum number of characters which can be displayed on the control panel screen is limited
(12 or 17 characters), the description of SP modes displayed on the screen needs to be abbreviated.
The following are the major abbreviations used for the SP modes for which the full description is over 12
or 17 characters.
1. Paper Type
N: Plain paper 1, N2 or Normal 2: Plain paper 2 (plain & recycled)
TC: Thick paper, Thick 1: Thick paper 1, Thick 2: Thick paper 2
TN: Thin paper
SP: Special paper
2. Color Mode [Color]
[K]: Black in B&W mode
[Y], [M], or [C]: Yellow, Magenta, or Cyan in Full Color mode
[YMC]: Only for Yellow, Magenta, and Cyan
[FC], [Cl]: Full Color mode
[FC, K], [FC, Y], [FC, M], or [FC, C]: Black, Yellow, Magenta, or Cyan in full color mode
3. Process Speed
LS: Low speed xx
RS: Regular speed xxx
HS: High speed xxx
As shown in the following table, the process speed (mm/s) depends on the print mode (B&W or Color),
resolution, and/or type of paper selected. Some SP mode settings depend on the process speed.
Mode Resolution (dpi) Line speed (mm/s) Print speed (ppm)
Plain Paper
600 x 600 260 40
1,200 x 1,200 85 15
5. System Maintenance Reference
254