1. Turn on the power switch of the printer.
• "Ready" shows on the panel display after the machine warms up.
2. Press the "Menu" key.
3. Press the " " or " " key to select "Language."
4. Press the "OK" key.
5. Press the " " or " " key to select the language you want.
6. Press the "OK" key.
7. Press the "Menu" key to return to the initial screen.
Printing the Test Page
You can check if the printer works correctly by printing a test page such as the configuration page.
However, you cannot check the connection between the printer and the computer by printing the test
page.
1. Turn on the power switch of the printer.
• "Ready" shows on the panel display after the machine warms up.
2. Press the "Menu" key.
3. Press the " " or " " key to select "List/Test Print".
4. Press the "OK" key.
5. Press the " " or " " key to select "Config. Page".
6. Press the "OK" key.
7. The test printing starts shortly after.
8. Press the "Menu" key to return to the initial screen.
9. Turn off the power switch of the printer.
Settings Relevant to the Service Contract
Change the necessary settings depending on the each customer's service contract. For details, refer to
"Meter Click Charge" following this section.
Meter Click Charge
Basically, there are two ways to set up this function.
2. Installation
42
To Next Page
Loading...
Need help?
General
