2524 [Thick1:SW Tmng:TE] DFU
Adjusts the bias/voltage switch timing of the paper transfer roller/discharge plate at
the paper trailing edge between the erase margin area and the image area.
Middle: 182 mm/sec, Low: 85 mm/sec
2-524-001 PTr:Mid:1st *ENG [0 to 50 / 0 / 2 mm/step]
2-524-002 PTr:Mid:2nd *ENG
2-524-003 PTr: Low : 1st *ENG
2-524-004 PTr: Low : 2nd *ENG
2-524-005 SepaDC:Mid:1st *ENG
2-524-006 SepaDC:Mid:2nd *ENG
2-524-007 SepaDC:Low:1st *ENG
2-524-008 SepaDC:Low:2nd *ENG
2530 [Thick1: EnvCor] DFU
2-530-013 SepaDC:Mid:1st *ENG [1 to 100 / 30 / 1 /step]
Adjusts the size correction coefficient
table of the thick 1 paper for the
discharge plate DC for each printing
side.
2-530-014 SepaDC:Mid:2nd *ENG
2-530-015 SepaDC:Low:1st *ENG
2-530-016 SepaDC:Low:2nd *ENG
[Thick1:Ed-Env.Cor] DFU
2-530-017 SepaDC:Mid:1st *ENG [1 to 100 / 30 / 1 /step]
Adjusts the size correction coefficient
table of the thick 1 paper for the
discharge plate DC (leading and
traiing edges) for each printing side.
2-530-018 SepaDC:Mid:2nd *ENG
2-530-019 SepaDC:Low:1st *ENG
2-530-020 SepaDC:Low:2nd *ENG
2551 [Thick2: Bias]
Adjusts the DC voltage of the discharge plate for thick 2 paper.
Engine SP Mode Tables - SP2000
345
To Next Page
Loading...
