3045 [TnrEnd Detect:Set]
Enables/disables the toner alert display on the LCD.
3-045-001 ON/OFF *ENG DFU
[0 or 1 / 0 / 1/step]
0: Detect, 1: Not Detect
3101 [Toner End/Near End]
Displays the amount of each color toner. DFU
3-101-001 Toner Replen.:Bk *ENG [1 to 600 / 360 / 1 g/step]
3-101-002 Toner Replen.:C *ENG
3-101-003 Toner Replen.:M *ENG
3-101-004 Toner Replen.:Y *ENG
005-008 Displays the consumed amount of each color toner.
3-101-005 Toner Consum.:Bk *ENG [0 to 3000 / 0 / 0.001 g/step]
3-101-006 Toner Consum.:C *ENG
3-101-007 Toner Consum.:M *ENG
3-101-008 Toner Consum.:Y *ENG
009-012 Displays the remaining amount of each color toner. These are calculated by the
operating times of the toner supply pumps.
3-101-009 Toner Remain.:Bk *ENG [–50000 to 600 / 0 / 0.001 g/step]
3-101-010 Toner Remain.:C *ENG
3-101-011 Toner Remain.:M *ENG
3-101-012 Toner Remain.:Y *ENG
013-016 Adjusts the threshold of toner near end for each color. The toner near end message
appears on the LCD when the remaining toner amount reaches this threshold. When
one of these SPs (SP3-101-009 to 012 or -032 to -035) reaches this threshold,
toner near end is detected.
Engine SP Mode Tables - SP3000
403