5840 [IEEE 802.11]
5-840-006 Channel MAX *CTL Sets the maximum number of channels available
for data transmission via the wireless LAN. The
number of channels available varies according
to location. The default settings are set for the
maximum end of the range for each area. Adjust
the upper 4 bits to set the maximum number of
channels.
EU: [1 to 13 / 13 / 1/step]
NA: [1 to 11 / 11 / 1/step]
AS: [1 to 14 / 14 / 1/step]
5-840-007 Channel MIN *CTL Sets the minimum number of channels available
for data transmission via the wireless LAN. The
number of channels available varies according
to location. The default settings are set for the
minimum end of the range for each area. Adjust
the lower 4 bits to set the minimum number of
channels.
EU: [1 to 13 / 1 / 1/step]
NA/ AS: [1 to 11 / 1 / 1/step]
AS: [1 to 14 / 14 / 1/step]
5-840-011 WEP Key Select *CTL Selects the WEP key.
[00 to 11 / 00 / 1 binary /step]
00: Key #1
01: Key #2 (Reserved)
10: Key #3 (Reserved)
11: Key #4 (Reserved)
5-840-045 WPA Debug Lvl *CTL Selects the debug level for WPA authentication
application.
[1 to 3 / 3 / 1 /step] 1: Info, 2: warning, 3:
error
This SP is displayed only when the IEEE802.11
card is installed.
Engine SP Mode Tables - SP5000
455
To Next Page
Loading...
