5-866-001 Report Validity *CTL Enables or disables the e-mail alert.
[0 or 1 / 0 / – /step]
0: Enable, 1: Disable
5-866-005 Add Date Field *CTL Adds or does not add the date field to the
header of the alert mail.
[0 or 1 / 0 / – /step]
0: Not added, 1: Added
5869 [RAM Disk Setting]
5-869-001 Mail Function *CTL [0 to 1 / 0 / 1/step]
0: ON, 1: OFF
Enables or disables the e-mail transfer function. This SP sets the RAM disk size for the
e-mail transfer function.
5870 [Common Key Info Writing]
5-870-001 Writing *CTL Rewrites the common certification used
for the @Remote.
5-870-003 Initialize *CTL -
Initializes the set certification.
When the GW controller board is replaced with a new one for repair, you must
execute the "Initiralize (-003)" and "Writing (-001)" just after the new board
replacement.
NOTE: Turn off and on the main power switch after the "Initiralize (-003)" and
"Writing (-001)" have been done.
5-870-004 Writing: 2048bit *CTL -
5873 [SD Card Appli Move]
5-873-001 Move Exec This SP copies the application programs from the original SD card
in SD card slot 2 to an SD card in SD card slot 1.
Engine SP Mode Tables - SP5000
465
To Next Page
Loading...
