Ricoh SP 3710DN - Page 157

Maintenance Mode (for Touch Panel Models)
SM 5-23 M0C3/M0C4/M0C5/M0C6/M0C7
System
Maintenance
Menu Description
[No Monitoring/ Up To Phase B (Default)/ All TX Phases]
Stop/Clear Key
Pressing the Stop/Clear key can stop the current receiving
operation. Received data is lost.
[No Functional (Default)/ Functional]
Off-Hook
Detection
Sets the Off-Hook detection period.
[200 msec (Default)/ 800 msec]
Number for
Remote Switch
[0～9 / 2 (Default/ 1digit/step]
Number of time
to press
[1～3 / 2 (Default/ 1time/step]
Period: TEL to
Fax
[Limitless / 10 sec (Default/ 20 sec / 30 sec / 40 sec]
TX Settings Redial Interval
Sets the redial interval when Tx fails.
[5 Min (Default)/ 6 Min]
Redialings
Sets the number of redials when Tx fails.
[2 times (Default)/ 3 Times/ 4 Times/ 5 Times]
Overseas
Comm Mode
Settings
Overseas
Comm Mode
This sets the machine to ignore a DIS signal sent from the
called station once in a sending operation.
[Off (Default)/ Ignore DIS Once]
Minimum Time
Length
If this setting is set to "On", the machine detects the CNG
signal after the line is connected. If it is set to "Off", the
machine detects the CNG signal as long as the line is
connected.
[100 Ms/ 200 Ms/ 300 Ms/ 400 Ms (Default)]
Dial Pulse
Setting
Dial Pulse Type
This sets the number of pulses that are generated during
dialing.
• N: Dialing '0' generates 10 pulses --- Dialing '9' generates
9 pulses. (Default)
• N+1: Dialing '0' generates 1 pulses --- Dialing '9' generates
10 pulses.
• 10-N: Dialing '0' generates 10 pulses --- Dialing '9'
generates 1 pulse.
Tone Signal Tone Signal
Sets the tone signal transmission time length