Ridder VitaLite-E - Page 26

Done Step Section
Check location and position "Location" on page23.
Connect the water components of the
unit
"Connecting water components
(water installation)" on the facing
page.
Connect the electrical system "Connecting electrical
components" on page29.
Connect the acid tank (partially filled
with water) and then connect the acid
tank float
"Connecting acid dosing
components" on page29.
Vent the acid pump and pipes "Connecting acid dosing
components" on page29.
Install quartz tubes "Installing quartz tubes" on
page32.
Pressurize the unit, bleed the air out,
and check for leaks
"Pressurizing the unit" on
page36.
Install UV-C lamps "Installing UV-C lamps" on
page37.
Connect tank sensors "Requirements for installing
water tank sensors" on page24.
Link to Synopta (optional) "Connecting Synopta" on page40.
Fill acid tank with acid "Chemicals" on page21.
Check parameters "Check settings" on page44.
Program activation conditions "Appendix A:Control overview"
on page59.
Testing the unit
Disinfection "Manually start disinfection" on
page44.
Cleaning quartz tubes "Manually start cleaning quartz
tubes" on page46.
Filter flushing "Manually start filter flushing" on
page47.
VitaLite
26