Message
The measured pH value is too high (disinfection)
Check the relevant preset value and alarm threshold.
Check whether the dosing pump is operating correctly.
Check whether the pH sensor is dirty or needs replacing because it is too old.
If necessary, recalibrate the sensor.
The measured pH value is too high (cleaning quartz tubes)
Check the relevant preset value and alarm threshold.
Check whether the dosing pump is operating correctly.
Check whether the pH sensor is dirty or needs replacing because it is too old.
If necessary, recalibrate the sensor.
The radiation sensor has generated an error message.
Check the device.
Dose flow too high
The flow regulated by the disinfected (water) valve is too high (if disinfection is
based on calibration curve).
Check the relevant preset value and alarm threshold.
Dose flow too low
The flow regulated by the disinfected (water) valve is too low (if disinfection is based
on calibration curve).
Check the relevant preset value and alarm threshold.
Flow too high (disinfection)
The following error has occurred during disinfection:
The measured flow rate is too high.
Check the relevant preset value and alarm threshold.
Check for leaks in the pipes.
Flow too high (cleaning quartz tubes)
The following error has occurred while the quartz tubes were being cleaned:
The measured flow rate is too high.
Check the relevant preset value and alarm threshold.
Check for leaks in the pipes.
Flow too high (filter flushing)
The following error has occurred while the filter was being flushed:
The measured flow rate is too high.
Check the relevant preset value and alarm threshold.
Check for leaks in the pipes.
VitaLite
93
To Next Page
Loading...
