Message
Flow too low (disinfection)
The following error has occurred during disinfection:
Check the relevant preset value and alarm threshold.
Check whether the pump is working.
Check whether any of the pipes are clogged.
Check whether the filter is clogged.
Flow too low (cleaning quartz tubes)
The following error has occurred while the quartz tubes were being cleaned:
The measured flow rate is too high.
Check whether the pump is working.
Check whether any of the pipes are clogged.
Check whether the filter is clogged.
Flow too low (filter flushing)
The following error has occurred while the filter was being flushed:
Check the relevant preset value and alarm threshold.
Check whether the pump is working.
Check whether any of the pipes are clogged.
Check whether the filter is clogged.
Monitor EC too high
The measured EC value is too high.
Check the relevant preset value and alarm threshold.
Check pre-blending control.
Check the sensor.
Monitor EC too low
The measured EC value is too low.
Check the relevant preset value and alarm threshold.
Check pre-blending control.
Check the sensor.
Control EC too high
The measured EC value is too high.
Check the relevant preset value and alarm threshold.
Check pre-blending control.
Check the sensor.
Control EC too low
The measured EC value is too low.
Check the relevant preset value and alarm threshold.
Check pre-blending control.
Check the sensor.
VitaLite
94
To Next Page
Loading...
