V L F > H F R E C E I V E R S
f
R & S E K 8 9 5 / R & S E K 8 9 6
User Manual
f
Control and Display Elements
Description
Upon acutation of the key PUT the
following appears on the display (36):
SELECT ADR 11 23 56 67 98 >
11, 23, 56, 67 and 98 are the last stored
slave addresses (= selection menu).
Entry of the required slave address is
either via the numeric keypad (27) or the
selection menu (see 3.1.23.1).
Via the numeric keypad addresses from 1
to 9 can be entered. The receiver with the
entered address takes over the master
receiver setting.
The stored slave addresses can be altered
acc. to 3.1.23.3.
By actuating key CLR numerical entries in
the display field (36) are cleared.
By actuating key CLR in the channel
editing menu the channel indicated in the
channel field (6) is cleared (disabled, see
3.1.16.2).
If the LED assigned to key NOTCH / PBT
(29) is illuminated, the set shift of the
receiver frequency within the IF passband
curve is reset to 0 by actuation of key CLR
and in the status line (2) there is no black
bar indicated above PBT.
By actuation of key ENT the numerical
displays in the display field (36) are stored.
By actuating key ENT in the channel
editing menu the channel indicated in the
channel field (6) is reactivated (see
3.1.16.3).
Control or display
element
DesignNo.
23
24
25
Pushbutton with
protective cap
(10.5¥10.5 mm)
CLR
ENT
Pushbutton with
protective cap
(10.5¥10.5 mm)
PUT
Pushbutton with
protective cap
(10.5¥10.5 mm)
for EK 896 only
6164.0717.02_01
> 3.84 >
To Next Page
Loading...
