V L F > H F R E C E I V E R S
f
R & S E K 8 9 5 / R & S E K 8 9 6
User Manual
f
List of Commands
6164.0717.02_01
> A3.51 >
Code Function (entry in) Input
Output
(requested with ?)
Remark
RESET Reset 0= software
reset
1= software
reset, RAM
test and
RAM clear
see A3.8.9
RS Reactivate channel 0 to 999 see A3.7.15
SA Signal BYPASS 0 to 2 0= high
(filter on)
1= low
(filter off)
2= ACTIVE
see A3.8.5
SE Switch digital selection on or
off (with R&S FK 896 or R&S
FK 896 only)
0 to 1 0= ON
1= OFF
see A3.7.20
SQ Switch squelch function on
or off
0 to 1 0= OFF
1= ON
see A3.7.21
SQT Set the squelch function
type
0 to 2 0= level squelch
1= syllabic
squelch
2= combined
see A3.7.22
SSBM Set the SSB filter mode 0 to 1 0= DATA
1= VOICE
see A3.7.24
SST Set the syllabic squelch level 0 to 100 0 to 100 see A3.7.6
ST Store into a channel 0 to 999 see A3.7.10
STC Start channel scanning with
freely programmed channel
list
see A3.6.1
STO Stop scanning see A3.4.2
see A3.5.2
see A3.6.2
STQ Start channel scanning see A3.5.1
STS Start frequency scanning see A3.4.1
SW Frequency scanning
parameters
Start frequency (Hz)
Stop frequency (Hz)
Increment (Hz)
0 to 30000000,
0 to 30000000,
1 to 30000000
0 to 30000000
0 to 30000000
1 to 30000000
see A3.4.4
V Inquire software version e.g. 01.31 see A3.8.2
To Next Page
Loading...
