EK895.TXT
F3: setting the frequency with the highest level
F3: RS 232 interface configuration:
COM port:
selection of active COM port (COM1, COM2) on computer
baud rate:
selection of active baud rate (110 to 19200)
parity:
setting the active parity (even, odd)
save parameter:
saving the following parameters in file ek895.cfg
- COM Port
- Baudrate
- Parity
- Address
the file ek895.cfg is placed in the same directory of the file
ek895.exe
F4: programming the scan parameters
Frequency sweep:
The parameters can be modified by pressing the associated keys as
indicated by the highlighted letters on the screen. Entries are
terminated with the RETURN key.
S (start frequency) value range 0 to 30000000 Hz, entry is in kHz.
T (stop frequency) value range 0 to 30000000 Hz, entry is in kHz.
E (step frequency) value range 1 to 30000000 Hz, entry is in kHz.
R (sweep threshold) value range 0 to 120 in steps of 5 db
D (dwell time) value range (10 to 65535 ms)
H (hold time) value range (0 to 65534 ms)
F (forever) infinite hold time
CH CH Sweep:
CH CH Tab.:
A maximum of 20 out of 1000 channels can be edited for a channel
scan routine in the vertical window. The channels are called up
during the scan routine starting with the first channel of the
list and following the order in which they were entered.
When no list has been entered:
The first channel to be edited is called up by pressing the
RETURN key. Value range 0 to 499. Editing is terminated by
pressing the RETURN again. Further entries are made the same
way.
When a list has been made up:
The required entry (two bars flashing) is selected with the
cursor up/down key. Press RETURN and enter new channel number,
then complete with RETURN.
F1: deleting all edited channels
Hold Dwelltime:
D (dwell time) value range (10 to 65535 ms)
H (hold time) value range (0 to 65534 ms)
To Next Page
Loading...
