Measurements
R&S
®
FSW
151User Manual 1173.9411.02 ─ 19
Note: User standards created on an analyzer of the R&S FSP family are compatible to
the R&S FSW. User standards created on an R&S FSW, however, are not necessarily
compatible to the analyzers of the R&S FSP family and may not work there.
The following parameter definitions are saved in a user-defined standard:
●
Number of adjacent channels
●
Channel bandwidth of transmission (Tx), adjacent (Adj) and alternate (Alt) chan-
nels
●
Channel spacings
●
Weighting filters
●
Resolution bandwidth
●
Video bandwidth
●
Detector
●
ACLR limits and their state
●
Sweep time and sweep time coupling
●
Trace and power mode
●
(MSR only: sub block and gap channel definition)
User-defined standards are managed in the "Manage" dialog box which is displayed
when you select the "Manage User Standards" button in the "General Settings" tab of
the "CP/ACLR Setup" dialog box.
In the "Manage" dialog box you can save the current measurement settings as a user-
defined standard, or load a stored measurement configuration. Furthermore, you can
delete an existing configuration file.
Channel Power and Adjacent-Channel Power (ACLR) Measurement
To Next Page
Loading...
