General Instrument Setup
R&S
®
FSW
583User Manual 1173.9411.02 ─ 19
The Secure User Mode can only be activated or deactivated by a user with administra-
tor rights.
Note: Storing instrument settings permanently. Before you activate secure user mode,
store any instrument settings that are required beyond the current session, such as
predefined instrument settings, transducer files, or self-alignment data.
For details on the secure user mode see chapter 3.1.7, "Protecting Data Using the
Secure User Mode", on page 37.
Remote command:
SYSTem:SECurity[:STATe] on page 1042
Note: Initially after installation of the R&S FSW-K33 option, secure user mode must be
enabled manually once before remote control is possible.
Changing the password ← Secure User Mode
When the secure user mode is activated the first time after installation, you are promp-
ted to change the passwords for all user accounts in order to improve system security.
To save the new password, select "Save". The password dialog for the next user is dis-
played, until you have been prompted to change the password all user accounts.
If you cancel the dialog without changing the password, the password dialog for the
next user is displayed, until you have been prompted to change the password all user
accounts. Although it is possible to continue in secure user mode without changing the
passwords (and you will not be prompted to do so again), it is strongly recommended
that you do define a more secure password for all users.
By default, the password characters are not displayed to ensure confidentiality during
input. To display the characters, select "Show password".
To display the onscreen keyboard, select "Keyboard".
9.3.5 Service Functions
When unexpected problems arise with the R&S FSW some service functions may help
you solve them.
General Instrument Settings
To Next Page
Loading...
