Measurements
R&S
®
FSW
115User Manual 1173.9411.02 ─ 19
For details see chapter 5.10, "Harmonic Distortion Measurement", on page 269.
Remote command:
CALCulate<n>:MARKer<m>:FUNCtion:HARMonics[:STATe] on page 796
First harmonic: CALCulate<n>:MARKer<m>:FUNCtion:CENTer on page 830.
THD: CALCulate<n>:MARKer<m>:FUNCtion:HARMonics:DISTortion?
on page 797
List of harmonics: CALCulate<n>:MARKer<m>:FUNCtion:HARMonics:LIST?
on page 798
chapter 11.5.10, "Measuring the Harmonic Distortion", on page 795
EMI
Detects electromagnetic interference in the signal, and opens a submenu to configure
the measurement.
For details see chapter 5.13, "Electromagnetic Interference (EMI) Measurement
(R&S FSW-K54)", on page 288.
Remote command:
CALCulate:MARKer:FUNCtion:FMEasurement:STATe on page 803
chapter 11.5.13, "Remote Commands for EMI Measurements", on page 803
Marker Functions
In addition to the measurement functions, some special marker functions are available.
See chapter 7.4.3, "Marker Function Configuration", on page 507.
All Functions Off
Switches off all measurement functions and returns to a basic frequency sweep.
5.2 Basic Measurements
Basic measurements are common sweeps in the time or frequency domain which pro-
vide an overview of the basic input signal characteristics.
If no other measurement function is selected, or if all measurement functions are
switched off, the R&S FSW performs a basic frequency or time sweep. After a preset,
a frequency sweep is performed.
Use the general measurement settings to configure the measurement, e.g. via the
"Overview" (see chapter 6, "Common Measurement Settings", on page 312).
5.2.1 How to Perform a Basic Sweep Measurement
To perform one or more single sweeps
1. Configure the frequency and span to be measured ("Frequency" dialog box, see
chapter 6.3, "Frequency and Span Configuration", on page 384).
Basic Measurements
To Next Page
Loading...
