Rohde & Schwarz FSW26 - Power Sensors

Common Measurement Settings
R&S
®
FSW
321User Manual 1173.9411.02 ─ 19
6.2.2.2 Probe Settings
Probes are configured in a separate tab on the "Input" dialog box which is displayed
when you select the INPUT/OUTPUT key and then "Input Source Config".
For each possible probe connector (Baseband Input I, Baseband Input Q), the detec-
ted type of probe, if any, is displayed. The following information is provided for each
connected probe:
●
Probe name
●
Serial number
●
R&S part number
●
Type of probe ("Differential", "Single Ended")
For more information on using probes with an R&S FSW, see chapter 6.2.1.3, "Using
Probes", on page 315.
For general information on the R&S
®
RTO probes, see the device manuals.
Microbutton Action...................................................................................................... 321
Microbutton Action
Active R&S probes (except for RT-ZS10E) have a configurable microbutton on the
probe head. By pressing this button, you can perform an action on the instrument
directly from the probe.
Select the action that you want to start from the probe:
"Run single"
Starts one data acquisition.
"No action"
Prevents unwanted actions due to unintended usage of the microbut-
ton.
Remote command:
[SENSe:]PROBe<p>:SETup:MODE on page 881
6.2.3 Power Sensors
The R&S FSW can also analyze data from a connected power sensor.
● Basics on Power Sensors..................................................................................... 322
● Power Sensor Settings..........................................................................................324
● How to Work With a Power Sensor.......................................................................328
Data Input and Output