Rohde & Schwarz FSW26 - Network and Remote Operation; Remote Control Basics; Remote Control Interfaces and Protocols

Network and Remote Operation
R&S
®
FSW
609User Manual 1173.9411.02 ─ 19
10 Network and Remote Operation
In addition to working with the R&S FSW interactively, located directly at the instru-
ment, it is also possible to operate and control it from a remote PC. Various methods
for remote control are supported:
●
Connecting the instrument to a (LAN) network
●
Using the LXI browser interface in a LAN network
●
Using the Windows Remote Desktop application in a LAN network
●
Connecting a PC via the GPIB interface
How to configure the remote control interfaces is described in chapter 10.5, "How to
Set Up a Network and Remote Control", on page 657.
● Remote Control Basics......................................................................................... 609
● GPIB Languages...................................................................................................645
● The IECWIN Tool..................................................................................................647
● Network and Remote Control Settings..................................................................648
● How to Set Up a Network and Remote Control.....................................................657
10.1 Remote Control Basics
Basic information on operating an instrument via remote control is provided here. this
information applies to all applications and operating modes on the R&S FSW.
10.1.1 Remote Control Interfaces and Protocols
The instrument supports different interfaces for remote control. The following table
gives an overview.
Remote Control Basics