Rohde & Schwarz FSW26 - Configuring the Network and Remote Control

Remote Commands
R&S
®
FSW
1035User Manual 1173.9411.02 ─ 19
Suffix Description
CMAP30 Limit and Margin Check – Text
CMAP31 Limit and Margin Check – \"Margin\"
CMAP32 *) Table Overall – Title Text
CMAP33 *) Table Overall – Title Background
CMAP34 *) Table Overall – Text
CMAP35 *) Table Overall – Background
CMAP36 *) Table Value – Title Text
CMAP37 *) Table Value – Title Background
CMAP38 *) Table Value – Text
CMAP39 *) Table Value – Background
CMAP40 Trace 5
CMAP41 Trace 6
*) these settings can only be defined via the theme (DISPlay:THEMe:SELect) and
are thus ignored in the SCPI command
11.10.5 Configuring the Network and Remote Control
The following commands are required to configure a network or remote control for the
R&S FSW.
Useful commands for configuring remote control described elsewhere:
● SYSTem:LANGuage on page 1050
Remote commands exclusive to configuring a network and remote control
SYSTem:COMMunicate:GPIB[:SELF]:ADDRess............................................................. 1035
SYSTem:COMMunicate:GPIB[:SELF]:RTERminator........................................................1036
SYSTem:DISPlay:UPDate............................................................................................ 1036
SYSTem:IDENtify:FACTory...........................................................................................1036
SYSTem:IDENtify[:STRing]...........................................................................................1037
SYSTem:LXI:INFo?......................................................................................................1037
SYSTem:LXI:LANReset................................................................................................1037
SYSTem:LXI:MDEScription...........................................................................................1037
SYSTem:LXI:PASSword...............................................................................................1037
SYSTem:COMMunicate:GPIB[:SELF]:ADDRess <Address>
This command sets the GPIB address of the R&S FSW.
Parameters:
<Address> Range: 0 to 30
*RST: (no influence on this parameter, factory default 20)
Configuring the R&S FSW