Rohde & Schwarz FSW26 - How to Work with Display and Limit Lines

Common Analysis and Display Functions
R&S
®
FSW
534User Manual 1173.9411.02 ─ 19
Insert Value
Inserts a data point in the limit line above the selected one in the "Edit Limit Line" dia-
log box.
Delete Value
Deletes the selected data point in the "Edit Limit Line" dialog box.
Shift x
Shifts the x-value of each data point horizontally by the defined shift width (as opposed
to an additive offset defined for the entire limit line, see "X-Offset" on page 530).
Remote command:
CALCulate:LIMit<k>:CONTrol:SHIFt on page 979
Shift y
Shifts the y-value of each data point vertically by the defined shift width (as opposed to
an additive offset defined for the entire limit line, see "Y-Offset" on page 531).
Remote command:
CALCulate:LIMit<k>:LOWer:SHIFt on page 981
CALCulate:LIMit<k>:UPPer:SHIFt on page 983
Save
Saves the currently edited limit line under the name defined in the "Name" field.
7.5.4 How to Work with Display and Limit Lines
Step-by-step instructions on configuring display and limit lines are provided here. For
details on individual functions and settings see chapter 7.5.3, "Settings and Functions
for Display and Limit Lines ", on page 527.
The remote commands required to perform these tasks are described in chap-
ter 11.8.4, "Configuring Display and Limit Lines", on page 975.
7.5.4.1 Defining Display Lines
1. Display lines are configured in the "Lines Config" dialog box. To display this dialog
box, press the LINES key and then "Lines Config".
2. Select the "Display Lines" tab.
3. To define a vertical line, select "Vertical Line 1" or 2 and enter the x-value at which
the line is to be displayed.
To define a horizontal line, select "Horizontal Line 1" or 2 and enter the y-value at
which the line is to be displayed.
Display and Limit Lines