Rohde & Schwarz FSW26 - Measuring Spurious Emissions

Remote Commands
R&S
®
FSW
765User Manual 1173.9411.02 ─ 19
CALC:LIM:FAIL?
//Queries the result of the limit check for all ranges.
TRAC:DATA? LIST
//Returns the peak for each range of the SEM measurement as a list.
11.5.7 Measuring Spurious Emissions
All remote control commands specific to spurious emissions measurements are descri-
bed here.
● Initializing the Measurement................................................................................. 765
● Configuring a Sweep List...................................................................................... 765
● Configuring the List Evaluation............................................................................. 773
● Performing a Spurious Measurement................................................................... 775
● Retrieving and Saving Settings and Results.........................................................775
● Programming Example: Spurious Emissions Measurement.................................775
11.5.7.1 Initializing the Measurement
Note that with the R&S FSW, the spurious measurement must be initialized before you
can start configuring the sweep list or list evaluation.
INITiate:SPURious......................................................................................................... 765
INITiate:SPURious
This command initiates a Spurious Emission measurement.
Usage:
Event
11.5.7.2 Configuring a Sweep List
The following commands configure the sweep list for spurious emission measure-
ments.
The sweep list cannot be configured using remote commands during an on-going
sweep operation.
Useful commands for configuring the sweep described elsewhere:
● [SENSe:]SWEep:MODE on page 731
Remote commands exclusive to spurious measurements:
[SENSe:]LIST:RANGe<range>:BANDwidth[:RESolution]....................................................766
[SENSe:]LIST:RANGe<range>:BANDwidth:VIDeo.............................................................766
[SENSe:]LIST:RANGe:BREak.........................................................................................767
[SENSe:]LIST:RANGe:COUNt?.......................................................................................767
[SENSe:]LIST:RANGe<range>:DELete............................................................................ 767
Configuring and Performing Measurements