Data Management
R&S
®
FSW
553User Manual 1173.9411.02 ─ 19
6. Select "Recall".
The settings and selected items from the saved measurement are restored and
you can repeat the measurement with the same settings.
To recall settings automatically after preset or reboot
You can define the settings that are restored when you preset or reboot the instrument.
1. Configure the settings as required and save them as described in "To save config-
urable instrument settings" on page 552.
2. In the "Save/Recall" menu, select the "Startup Recall" softkey.
3. If the file selection dialog box is not displayed automatically, select the "Select
Dataset" softkey.
4. Select the recall settings that are to be restored.
5. Select "Select".
6. Toggle the "Startup Recall" softkey to "On".
Now when you press the PRESET key or reboot the instrument, the defined set-
tings will be restored.
7. To restore the factory preset settings, toggle the "Startup Recall" softkey to "Off".
8.4 Importing and Exporting Measurement Results for
Evaluation
The R&S FSW provides various evaluation methods for the results of the performed
measurements. However, you may want to evaluate the data with further, external
applications. In this case, you can export the measurement data to a standard format
file (ASCII or XML). Some of the data stored in these formats can also be re-imported
to the R&S FSW for further evaluation at a later time, for example in other applications.
The following data types can be exported:
●
Trace data
●
Table results, such as result summaries, marker peak lists etc.
●
I/Q data
The following data types can be imported:
●
I/Q data
I/Q data can only be imported and exported in applications that process I/Q data, such
as the I/Q Analyzer or optional applications.
See the corresponding user manuals for those applications for details.
Importing and Exporting Measurement Results for Evaluation
To Next Page
Loading...
