General Instrument Setup
R&S
®
FSW
571User Manual 1173.9411.02 ─ 19
"Ouput 640 MHz"
Provides a 640 MHz reference signal to the REF OUTPUT 640 MHZ
connector.
"Output Sync Trigger"
Provides a 100 MHz reference signal to the SYNC TRIGGER
OUTPUT connector.
Remote command:
[SENSe:]ROSCillator:O100 on page 1019
[SENSe:]ROSCillator:O640 on page 1019
[SENSe:]ROSCillator:OSYNc on page 1020
Resetting the Default Values
The values for the "Tuning Range", "Frequency" and "Loop Bandwidth" are stored for
each source of "Reference Frequency Input". Thus, when you switch the input source,
the previously defined settings are restored. You can restore the default values for all
input sources using the "Preset Channel" function.
9.3.2 Transducer Settings
Up to 8 transducer lines can be activated simultaneously in the R&S FSW. Many more
can be stored on the instrument.
The transducer settings are defined in the "Transducer" dialog box which is displayed
when you press the SETUP key and then select "Transducer".
Transducers can also be defined when an optional external mixer is used (R&S FSW-
B21).
Transducer settings in secure user mode
Be sure to store transducer files before Secure User Mode is enabled; see chap-
ter 3.1.7, "Protecting Data Using the Secure User Mode", on page 37.
● Transducer Management......................................................................................571
● Transducer Factors...............................................................................................574
9.3.2.1 Transducer Management
The settings required to manage all transducer lines on the instrument are described
here.
General Instrument Settings
To Next Page
Loading...
