Rohde & Schwarz FSW26 - Using Service Functions

Remote Commands
R&S
®
FSW
1043User Manual 1173.9411.02 ─ 19
11.10.7 Using Service Functions
DIAGnostic:SERVice:SFUNction................................................................................... 1043
DIAGnostic:SERVice:SFUNction:LASTresult?.................................................................1043
DIAGnostic:SERVice:SFUNction:RESults:DELete........................................................... 1043
DIAGnostic:SERVice:SFUNction:RESults:SAVE............................................................. 1043
DIAGnostic:SERVice:SINFo?........................................................................................ 1044
DIAGnostic:SERVice:SFUNction <ServiceFunction>
This command starts a service function.
The service functions are available after you have entered the level 1 or level 2 system
password.
Parameters:
<ServiceFunction> String containing the ID of the service function.
The ID of the service function is made up out of five numbers,
separated by a point.
• function group number
• board number
• function number
• parameter 1 (see the Service Manual)
• parameter 2 (see the Service Manual)
Usage: Event
Manual operation: See "Service Function" on page 588
See "Send" on page 589
DIAGnostic:SERVice:SFUNction:LASTresult?
This command queries the results of the most recent service function you have used.
Usage:
Query only
DIAGnostic:SERVice:SFUNction:RESults:DELete
This command deletes the results of the most recent service function you have used.
Usage:
Event
Manual operation: See "Clear Results" on page 589
DIAGnostic:SERVice:SFUNction:RESults:SAVE <FileName>
This command saves the results of the most recent service function you have used.
Parameters:
<FileName> String containing the file name.
Manual operation: See "Save Results" on page 589
Configuring the R&S FSW