Rohde & Schwarz FSW26 - Table of Contents

Measurements
R&S
®
FSW
243User Manual 1173.9411.02 ─ 19
Range Start / Range Stop...........................................................................................243
Filter Type................................................................................................................... 243
RBW............................................................................................................................244
VBW............................................................................................................................244
Sweep Time Mode...................................................................................................... 244
Sweep Time................................................................................................................ 244
Detector.......................................................................................................................244
Ref. Level....................................................................................................................244
RF Att. Mode...............................................................................................................245
RF Attenuator..............................................................................................................245
Preamp........................................................................................................................245
Sweep Points.............................................................................................................. 245
Stop After Sweep........................................................................................................ 245
Transducer..................................................................................................................245
Limit Check................................................................................................................. 246
Abs Limit Start/Stop.................................................................................................... 246
Insert before/after Range............................................................................................ 246
Delete Range.............................................................................................................. 246
Range Start / Range Stop
Sets the start frequency/stop frequency of the selected range.
If you set a span that is smaller than the overall span of the ranges, the measurement
includes only the ranges that lie within the defined span and have a minimum span of
20 Hz.
Remote command:
[SENSe:]LIST:RANGe<range>[:FREQuency]:STARt on page 769
[SENSe:]LIST:RANGe<range>[:FREQuency]:STOP on page 769
Filter Type
Sets the filter type for this range.
Spurious Emissions Measurement